PROBECAP
$3.49 USD
Want to protect your temperature probe kettle connections when rinsing your kettles? Add a water-resistant/splash-proof silicone temperature probe cap to stop water from getting into the connector when your cable is disconnected.
Works on all of our temperature probes. Simply remove the four screws to install between the probe flanges. The cover pops on and off as needed and will not get lost.
These caps are already included with all of our Electric Brewery temperature probes.
Note: These caps are not guaranteed waterproof. Do not submerge a probe connector in water with cap connected.
$79.95 USD
ON SALE! Use coupon code SAVE15 at checkout and save 15% until April 1. Metric (straight) thread probes are normally used directly in a kettle wall such as the Boil Kettle, resulting in a weldless installation. Simply punch a hole in...
$76.95 USD
ON SALE! Use coupon code SAVE15 at checkout and save 15% until April 1. NPT (tapered) thread probes are normally attached directly to plumbing, or existing kettle fittings. Mounts into 1/2" NPT thread (as well as 1/2" BSPP and BSPT). The 1.5" long probe (measured...
$77.95 USD
ON SALE! Use coupon code SAVE15 at checkout and save 15% until April 1. NPT (tapered) thread probes are normally attached directly to plumbing, or existing kettle fittings. Mounts into 1/4" NPT thread (as well as 1/4" BSPP and BSPT). Simply wrap...
$87.95 USD
ON SALE! Use coupon code SAVE15 at checkout and save 15% until April 1. Tri-Clamp (sometimes called Tri-Clover) probes are normally attached directly to plumbing or existing kettle fittings using a clamp and gasket (not included). Includes two layers of sleeving,...
© 2024 The Electric Brewery. All rights reserved. Powered by Shopify